Hydraulic gear pump test bench HP-B液压泵55KW试验台；
Operation control instructions
1.
1.
Before use, check whether the adjusting screws of all components and accessories in the
system are in the correct position, whether the oil is within the indication range of the liquid
level gauge, and whether the pipe joints and fastening screws are loose. If everything is
normal, the hydraulic system can be put into operation.
2.
2.
Before starting and stopping the motor, the loading, oil supply, pilot and speed
adjustment shall be left to zero to make the motor start or stop under no-load state.
3.
3.
If the oil suction and return filters are blocked during use, the indicator light will send a
signal (the red light is on).
4.
4.
The locked overflow valve shall not be adjusted at will.
5.
5.
The oil level should not be lower than the level gauge. If there is insufficient oil, it should
be filled in time. The method is as follows: 5, 2.
6.
6.
In case of system failure, stop the machine in time for inspection.
7.
7.
During the use of this hydraulic system, detailed records should be made on the
replacement of oil, components and auxiliary parts, and fault handling, so as to facilitate
future repair, maintenance and fault analysi
